Skip links and keyboard navigation

Station overview—Mountain Creek

Location of Mountain Creek

Map marker is indicative only. It does not reflect the exact location of the station.
See all stations in South East Queensland region.

This station is located at the Mountain Creek State Primary School on the Sunshine Coast and was established in July 2001.

Monitoring period
1 July 2001–
Parameters monitored

Current measurements at 2am 12 October 2024

Air quality
ParameterMeasurementRunning average
Particle PM2.54.4µg/m³5µg/m³ (24hr avg)
Particle PM1011.5µg/m³13µg/m³ (24hr avg)
Nitrogen dioxide0.002ppm0.002ppm (1hr avg)
Ozoneoffline-
Visibility7Mm⁻¹7Mm⁻¹ (1hr avg)
Meteorological
ParameterMeasurement
Wind direction219deg
Wind speed0.8m/s
Temperature15.2°C

Legend to air quality category colours about category values

  • Good
  • Fair
  • Poor
  • Very poor
  • Extremely poor

None of the data is validated (0% validated, 0/8 records)

An offline message in a cell indicates that measurements are temporarily unavailable due to equipment servicing or failure. See network status.

About air quality categories

Air quality categories are used to make it easier to interpret air quality data by reducing the complexity associated with different pollutant concentration units and air quality guideline values.

Each air quality measurement from a monitoring station is assigned an air quality category rating based on comparison of the measurement value against the relevant air quality guideline. Five colour-coded air quality categories are used, being ‘Good’ (green), ‘Fair’ (yellow), ‘Poor’ (orange), ‘Very poor’ (red) or ‘Extremely poor’ (dark red). Values greater than the air quality guideline will be appear as ‘Poor’, ‘Very poor’ or ‘Extremely poor’.

More information about air quality categories.

About these parameters

Particle PM2.5

Airborne particles less than 2.5 micrometres in diameter, referred to as PM2.5, can be hazardous to human health or cause a nuisance when present in the air at elevated levels. They are capable of penetrating the lower airways of humans and can cause possible negative health effects.

The guideline for Particle PM2.5 is 50µg/m³ (1hr avg) and 25µg/m³ (24hr avg).

Particle PM2.5 is measured in micrograms per cubic metre.

More information about Particle PM2.5

Particle PM10

Airborne particles less than 10 micrometres in diameter, referred to as PM10, can be hazardous to human health or cause a nuisance when present in the air at elevated levels. They are capable of penetrating the lower airways of humans and can cause possible negative health effects.

The guideline for Particle PM10 is 100µg/m³ (1hr avg) and 50µg/m³ (24hr avg).

Particle PM10 is measured in micrograms per cubic metre.

More information about Particle PM10

Nitrogen dioxide

Nitrogen dioxide is an acidic and highly corrosive gas. Nitrogen oxides are critical components of photochemical smog. Long-term exposure to high levels of nitrogen dioxide can cause chronic lung disease and affect the senses.

The guideline for Nitrogen dioxide is 0.08ppm (1hr avg).

Nitrogen dioxide is measured in parts per million.

More information about Nitrogen dioxide

Ozone

Ozone is a colourless, highly reactive gas with a distinctive odour. The upper atmosphere ozone layer (at altitudes of 15–35km) protects the earth from harmful ultraviolet radiation from the sun. The ozone layer reduction represents a global atmosphere issue.

The guideline for Ozone is 0.1ppm (1hr avg) and 0.065ppm (8hr avg).

Ozone is measured in parts per million.

More information about Ozone

Visibility

Aerosols and fine particles can reduce visibility. Smoke from fires or haze are common causes of poor visibility.

The guideline for Visibility is 235Mm⁻¹ (1hr avg).

Visibility is measured in inverse megametres.

More information about Visibility

Wind direction

When high pollutant concentrations occur at a monitoring station, wind data records can determine the general direction and area of the emissions. Identifying the sources means planning to reduce the impacts on air quality can take place. The measurement indicates the direction the wind is coming from.

Wind direction is measured in degrees.

More information about Wind direction

Wind speed

When high pollutant concentrations occur at a monitoring station, wind data records can determine the general direction and area of the emissions. Identifying the sources means planning to reduce the impacts on air quality can take place.

Wind speed is measured in metres per second.

More information about Wind speed

Temperature

Measuring temperature supports air quality assessment, air quality modelling and forecasting activities.

Temperature is measured in degrees Celsius.

More information about Temperature

Licence
Creative Commons Attribution 4.0 International (CC BY 4.0)
Last updated
8 July 2024